download the pdf (735K)

Parts List
2 Threaded chair legs
2 Non-threaded chair legs
2 Crossbars, marked “front” & “back”
1 Seat bottom with adjustable straps
1 Chair back (canvas & armrests attached)
1 Chair Top Crossbar

Assembly Instructions:
Step 1: Find two threaded chair legs and crossbar marked “front”.
Step 2: Slide crossbar aluminum brackets over threaded legs with the word “front” face up. Place on ground.
Step 3: Grab seat bottom, holding side bars IMPORTANT make sure smooth hardware faces out and bolt in with seat pad closest to the ground. Place aluminum brackets over the threaded legs.
Step 4: Insert non-threaded chair legs into existing aluminum brackets.
Step 5: Slide crossbar marked “back” on top of aluminum brackets with the word “back” face down.
Step 6: Tuck seat flap and webbing under “front” crossbar. Line up seat pad with crossbar.
Step 7: Fold remaining seat flap over “back” crossbar and connect buckles. Wait to tighten.
Step 8: Stand chair up.
Step 9: Place chair back armrests over non-threaded legs, gently push down until seated. Snap chair back buckles by guiding strap under chair seat and around the outside, secure buckle and tighten strap gently.
Step 10: Thread front legs into armrests and hand tighten. Pull straps taunt under seat bottom.
Step 11: If needed tighten fastener nuts on either side of chair armrests.
Step 12: Place top crossbar on chair back with hardware closest to the top……YOU DID IT! ENJOY!!!!